Onkyo TXNR727 En-73, Remote Controller Setup, Lock Setup, Initial Setup, Remote ID

■Proxy Port

If you’re using a Web proxy, enter a proxy port number here.

■Network Standby

`On

`Off

This setting enables or disables control over the network.

When enabled, the NET indicator will be dimly-lit while the AV receiver is in standby mode. Note that the indicator may not light under certain conditions (➔ page 22).

Note

•When set to “On”, the power consumption slightly increases in standby mode.

■Update Notice

`Enable

`Disable

When this setting is enabled, you will be notified if a firmware update via network of high importance is available.

Note

•Selecting “Never Remind me” on the notification window will switch this setting to “Disable” (➔ page 22).

•For details on the update notification, see “Firmware Update Notification” (➔ page 22).

■Bluetooth

This setting enables the AV receiver to pair with Bluetooth-enabled device.

Status

Press ENTER button to display “Now Pairing” and start pairing.

Tip

•If pairing setting is not set, “Ready” appears on-screen display. The name of the device paired with the AV receiver is displayed if pairing setting is set.

•For details on the Bluetooth connection, refer to the instruction manual of the Bluetooth-enabled device.

•The pairing can be done by holding down BLUETOOTH button on the AV receiver until BLUETOOTH indicator flashes.

Note

•This setting cannot be selected if you’ve selected NET or USB as input selector in Multi Zone.

Initial Setup

If you skipped the initial setup wizard, for example on first-time use, you can reaccess it from here.

See “Initial Setup” (➔ page 22).

Note

•This setting cannot be selected if the “Monitor Out” setting is set to “Sub”.

Advanced Operations

8. Remote Controller Setup

Remote ID

■Remote ID

`1, 2, or 3

When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate the AV receiver from other components, you can change its remote ID from “1”, to “2” or “3”.

Note

•If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won’t be able to control it with the remote controller.

Changing the remote controller’s ID

1	While holding down RECEIVER, press and
	hold down Q SETUP until the remote indicator
	lights (about 3 seconds).
2	Use the number buttons to enter ID 1, 2, or 3.
	The remote indicator flashes twice.

Remote Mode Setup

See “Looking up for Remote Control Codes”

(➔ page 76).

9. Lock Setup

With this preference, you can protect your settings by locking the setup menus.

■Setup

`Locked

`Unlocked

When “Locked” is selected, the setup menus will be locked and you cannot change any setting.

En-73

Operating procedure (➔ page 56)