Firmware Update Notification

When a new version of the firmware is available, the notification window “Firmware Update Available” pops up. This notification only appears when the AV receiver is connected to the Internet (pages 16, 27). To perform the firmware update, follow the instructions on screen.

Use q/wand ENTER on the AV receiver or remote controller to select one of the options.

`Update Now:

Starts the firmware update.

Refer to “Firmware Update” (page 90).

`Remind me Later:

The update notification will pop up again the next time you turn the AV receiver on.

`Never Remind me:

Disables the automatic update notification.

Tip

The update notification window can be enabled or disabled in “Update Notice” (page 73).

About the HYBRID STANDBY indicator

By way of optimized circuitry, this function reduces power consumption when the AV receiver is in standby mode. The HYBRID STANDBY indicator will light in either of the following conditions:

–“HDMI Through” is enabled (the HDMI indicator is off).

–“Network Standby” is enabled (the NET indicator is off).

Note

If Zones are turned on or, if a mobile device connected to the Front Input (MHL) is charging, the HYBRID STANDBY indicator won’t light.

Initial Setup

This section explains the settings that we recommend you to make before using the AV receiver for the very first time. A setup wizard is launched upon first-time use to let you perform those settings.

Tip

The on-screen menus appear only on a TV that is connected to HDMI OUT MAIN.

Selecting the Language for the On- screen Setup Menus

This step determines the language used for the on- screen setup menus. See “Language” in “OSD Setup” (page 69).

Tip

Pressing HOME will close the setup wizard. To restart the initial setup, select “Initial Setup” in the “Hardware Setup” menu (page 73).

After selecting the language for on-screen setup menus, a welcome screen is displayed.

Initial Setup

Welcome to initial setup. Have you connected all the speakers and devices?

Before starting, please connect speakers and sources.

Now, would you like to start initial setup?

1st Step : Audyssey MultEQ: Auto Setup

2nd Step : Source Connection

3rd Step : Remote Mode Setup

4th Step : Network Connection

Yes

No

HOME Exit

Turning On & Basic Operations

1 Use q/won the AV receiver or remote controller to select one of the following options, and then press ENTER.

`Yes:

Continues to “Audyssey MultEQ: Auto

Setup”.

`No:

Skips the settings and terminates the initial setup. The setup wizard goes to “Terminating the Initial Setup” (page 23). You can always restart the initial setup by selecting “Initial Setup” in the “Hardware Setup” menu (page 73).

Audyssey MultEQ: Auto Setup

This step performs the automatic speaker setup.

1 Use q/wto select one of the following options, and then press ENTER.

`Do it Now:

The automatic speaker setup is performed following instructions on screen. Refer to step 2 of “Using the Automatic Speaker Setup” (page 24). When this setting is complete, the setup wizard continues to “Source Connection”.

`Do it Later:

Skips this setting.

Press ENTER and continue to “Source

Connection”.

En-22

Page 22
Image 22
Onkyo TXNR727 instruction manual Initial Setup, En-22