Manual wireless LAN setup
1 | Press RECEIVER followed by HOME. |
2 | Use e/ror q/wto select “Setup”, and then |
| press ENTER. |
3 | Use q/wto select “Hardware Setup”, and then |
| press ENTER. |
4 | Use q/wto select “Network”, and then press |
| ENTER. |
5 | Use q/wto select “Network Connection”, and |
| e/rto select “Wireless”, and then press |
| ENTER (➔ page 72). |
The “Wireless Setup” menu is displayed on screen.
Tip
•The same setting is available even if “Wireless” is selected in “Network Connection” in initial setup (➔ page 23).
6 Use q/wto select “Search Wireless Network” and then press ENTER.
A list of available Access Points is displayed.
Tip
•If Access Point you wish to connect to is not displayed in the list of available Access Points, the setting also can be made by entering “SSID”, “Security”, and “Password” manually after selecting “Direct Input”.
|
|
| Turning On & Basic Operations |
7 Use q/wto select the Access Point you wish to | 8 Select “OK” and press ENTER. | ||
connect to, and then press ENTER. |
| Connection to your Access Point starts and | |
Depending on your encryption settings, the |
| indicator flashes. After the connection to your | |
security of your Access Point will provide one of |
| Access Point is completed, | |
the following patterns: |
| and the connection status is displayed on the | |
■ WEP method |
| screen. | |
| This completes the wireless LAN setup. | ||
1. Use q/wto select “Default Key ID” and then |
| ||
| You can review your setup with the “Status” | ||
press ENTER. |
| ||
| option on the “Wireless Setup” menu. | ||
2. Use q/wto choose an ID between 1 and 4, |
| ||
|
|
| |
| Note |
| |
and then press ENTER. |
|
| |
| • If | ||
3. Use q/wto select “Password” and then press |
| ||
| Access Point is not done successfully. Configure this | ||
ENTER. |
| ||
| setting again (➔ page 85). | ||
4. Use the keyboard on screen to enter the |
| ||
|
|
| |
password and confirm with “OK”. |
|
|
|
■WPA/WPA2 method
1.Use q/wto select “Password” and then press
ENTER.
2.Use the keyboard on screen to enter the password and confirm with “OK”.
■No encryption
If your Access Point device is not secured by encryption, there is no need to input any secret key.
Tip
•When you select the Access Point you wish to connect to from the list of available Access Points, “SSID” and “Security” are automatically displayed. These settings can be changed manually.
