Heatsink Installation

+IMPORTANT:

Apply suitable thermal grease and make sure all heat pads are in position before replacing module.

!CAUTION:

Thermal grease can damage mainboard. Use caution when applying. The following thermal grease types are approved for use:

Silmore GP50 Honeywell Jet Motor 7762

The following thermal pads are approved for use: Eapus XR-PE

1.Remove all traces of thermal grease from CPU using a lint-free cloth or cotton swab and Isopropyl Alcohol, Acetone, or other approved cleaning agent.

2.Apply small amount of thermal grease to center of CPU.

NOTE: NOTE:

Force used during installation of thermal module is sufficient to spread grease over CPU top.

3.Install and secure four (4) thermal screws (B) in numerical order from one (1) to four (4) to mainboard. (Figure 3-32)

4.Install and secure two (2) captive screws (C) to mainboard. (Figure 3-32)

5.Install fan.

Figure 3-35. Thermal Module

+IMPORTANT:

Circuit boards >10 cm² have been highlighted with a yellow rectangle as shown in Figure 3-35. Remove the Circuit board and follow local regulations for disposal.

Machine Maintenance Procedures

3-37

Page 117
Image 117
Packard Bell TK11BZ, TK13BZ manual Heatsink Installation, Thermal Module