Packard Bell TK11BZ manual Using the LAN MAC Eeprom Utility, LAN MAC Eeprom Parameter Description

Using the LAN MAC EEPROM Utility

Perform the following steps to write MAC (Media Access Control) information to EEPROM:

Use the MAC.BAT utility to write the MAC.CFG file to the EEPROM under DOS mode.

1.Use a text editor (Ex: Notepad) to open the MAC.CFG file. See the MAC.CFG contents in Figure 2-25

Figure 2-25. LAN MAC EEPROM

Table 2-5. LAN MAC EEPROM

Parameter	Description
WriteData = ‘001122334455'	MAC value
StartAddr=7A	MAC address
WriteLeng=6	MAC value length
KeepByte=0	Value not important

2.Enter into DOS.

3.Run the MAC.BAT file to write MAC values to EEPROM.

Figure 2-26. LAN MAC EEPROM

4.Reboot the system when the process has completed.

System Utilities 2-25