Reset the SLAVE camera to CAMERA mode.
7
During dubbing, reset the counter value at the OUT point to stop dubbing with memory stop mode. (Page 81)
1394TC preset mode
When shooting using a multi-camera, you can synchronously set the initial values of TC. The camera used for synchronization is the MASTER and the camera being synchronized is the SLAVE.
1 Connect a second camera with a 1394 cable and turn both cameras on.
• For connection (Page 78)
2 Put the MASTER camera in CAMERA mode
and output a video signal from the 1394 terminal.
• Set both cameras to the same recording format.
Do the remaining steps on the SLAVE camera.
3 Set the SLAVE camera to MCR/VCR mode and in the setup menus, RECORDING SETUP screen, set FIRST REC TC to PRESET mode so the counter shows the TCG.
• You cannot do this if you have selected
REGEN.
4 In the setup menus, RECORDING SETUP screen, set 1394 IN PRESET to ON. (Page 108)
• 1394TC appears on the screen.
5 Stop or eject the cassette tape.
6 Press the COUNTER RESET/TC SET button. The TCG value is preset with the TC value from the input 1394 signal.
When rewind or fast-forward the tape, it stops automatically near where you reset the counter.
5
4 Press the mode button to switch to the VCR mode. (Page 63)
Proceed with playback or shooting.
3
Using the Counter
Counter display (P2 card / Tape)
You can display a counter that indicates how much time has elapsed during shooting or playback.
COUNTER button
Cameraor
BARS SHUTTER SPEED SEL
RESET
CH 1 SELECT CH 2 SELECT | INPUT 1 | INPUT 2 |
INT(L) | INT(R) | ON | ON |
INPUT 1 | INPUT 2 | OFF | OFF |
INPUT 2 | | | | |
| AUDIO | MIC POWER +48V |
COUNTER | RESET/TC SET | ZEBRA | OIS |
Remote control
START/
DATE/ PHOTO STOP
OSD TIME SHOT
COUNTER RESET TITLE ZOOM
MULTI/ | REC A.DUB | + |
P-IN-P |
| | - VOL |
/REW PLAY FF/
COUNTER RESET/TC SET button
1Press the COUNTER button.
Each time you press the button, the display changes as follows. (Page 90)
0 : 00. 00 Counter value
In the P2 mode, the counter is not displayed during playback.
M 0 : 00. 00 (Tape only)
Counter value in memory stop mode
TC XX : XX : XX : XX Time code value
UB XX XX XX XX User information
FR --- -
Frame rate (30P/24P/24PA) and frame sequence in progressive mode shooting.
No display:
Data is not displayed.
Resetting the counter
Press the COUNTER RESET button while the counter is displayed.
Memory stop mode (Tape)
After shooting or playback, the tape can first be returned to near the pre-programmed position, and then stopped automatically.
1Press the COUNTER button to display the counter in memory stop mode.
2At the desired position on the tape, press the COUNTER RESET button to reset the counter.
