Screen displays

Regular displays

1Time code displays

Each time you press the COUNTER button, the display switches over to the following data (or no indication).

COUNTER: (Tape or P2-camera mode only) Counter value

M COUNTER: (Tape only)

Counter value in memory stop mode

TC:

Time code value. When the time code value could not be read correctly from the tape, [TC*] is displayed.

When it acts in drop frame mode, the colon between seconds and frames become “.”.

UB:

User information

When user information could not be read correctly from the tape, [UB*] is displayed.

FR:

Frame rate information for recording

FR 60I : Standard (60i interlace) mode (60 fields/sec.)

FR 60P : 60P progressive mode (60 frames/ sec.)

FR 30P : 30P progressive mode (30 frames/ sec.)

FR 24P : 24P progressive mode (24 frames/ sec.)

FR 24PA : 24P advanced mode

When in FR24P and FR 24PA mode, the sequence information of the frame conversion at the final place.

2Warnings

REMOTE:

Blinks when the wrong equipment setting is selected on the remote control unit.

:

Lights when condensation has formed inside the camera-recorder.

:

Blinks when cylinder heads are dirty.

P2 or :

Blinks when a P2 card or tape has not been inserted, or when the camera is in a write- protected state.

P2 FULL or END:

Blinks when either there is no remaining capacity in the P2 card or the tape has reached the end.

P2 LACK:

Blinks in the loop rec mode when the remaining capacity of the P2 card is insufficient.

:

Lights when the internal battery for the calendar has run out.

3AUTO/MANUAL switch operation display This display appears if a function which has been set on the setting menu AUTO SW screen is operating when the AUTO/MANUAL switch has been pressed.

90