•When you wish to start dubbing from a point mid-way along a clip, first play back the clip, then press the button at the desired position to pause playback.

REC

 

 

 

Camera

 

 

 

or

COUNTER RESET TITLE ZOOM

 

MULTI/

A.DUB

+

 

P-IN-P REC

 

 

 

ÐVOL

 

/REW PLAY

FF/

 

Remote control

 

 

 

STILL ADV PAUSE STILL ADV

 

 

INDEX STOP

INDEX

 

 

7Hold down the mode button (for 2 or more seconds) to release dubbing mode.

•In the VCR setting menu, setting the TCG option in RECORDING SETUP to FREE RUN enables the timecode used by the clip to be transferred to the tape.

•In the case of a clip recorded in four channels, the audio of channels 3 and 4 will not be transferred during the dubbing process.

•The dubbing IN points may be slightly ahead of or behind their actual positions.

•In the case of clips recorded continuously onto three or more cards, dub the clips on two of the cards first. After this, stop the dubbing, and replace the cards with the third and subsequent cards. Then resume the dubbing. (These steps are taken because hot swap playback cannot be performed.)

•In the dubbing mode, even if an attempt is made to allocate SHOT MARK, INDEX/MEMO or SLOT SEL to a USER button, the allocated operation will not be executed. However, the allocated USER button information will be displayed when the DISP/MODE CHK button is held down.

Digital input/output (P2 card/Tape)

You can perform dubbing with a high image quality by means of digital signals by using a 1394 cable to connect this unit to a digital video unit equipped with a 1394 connector.

• Use the MEDIA switch to select the P2 card or tape ahead of time. (Pages 25 and 29)

1Connect the digital video equipment to this unit. (Page 78)

2Press the unit’s mode button to switch to the MCR/VCR mode.

CAMERA

MCR VCR

PC DUB

•Cancel the thumbnail screen when in MCR mode.

•Set up the connected equipment for playback or recording.

•When performing digital dubbing with a second camera-recorder or other device, a recording cannot be made unless the signal formats at the output side and input side are identical.

•When using with the 720P/24PN and 720P/30PN settings, digital output in MCR mode only is performed. Digital input is not possible.

•1394 input images cannot be output from the COMPONENT OUT terminal.

3Start playing back in the player.

4Start recording in the recorder.

•If you are using this unit, press the two REC buttons at the same time. On the remote control unit, press the PLAY button while

holding down the REC button.

REC

COUNTER RESET TITLE ZOOM

MULTI/

REC A.DUB

+

P-IN-P

 

 

ÐVOL

/REW PLAY FF/

STILL ADV PAUSE STILL ADV

INDEX STOP INDEX

Camera or Remote control

•In the VCR mode, the recording standby status is established when these two buttons are pressed together in the playback pause status. (The recording standby status will not be established in the MCR mode.) Each time

you press the button, the status switches between recording and recording standby.

5Stop recording in the recorder.

• On this unit, press the button.

6Stop playback on the other unit.

• On this unit, press the button.

Editing

87