
Copying from P2 cards to the hard disk drive (1394 HOST mode) P2
•Use an HDD (hard disk drive) that has sufficient capacity to permit copying.
•Before copying the data, format the hard disk drive so that it can be used by the unit. Bear in mind that this process will delete all the data on the drive.
•Connect the camera to an HDD using the 1394 cable. (Page 77)
Do not connect the camera to two or more HDD (chain, hub, etc.), even if they are not switched ON.
•Insert the P2 card into the unit, and set the MEDIA switch to the P2 position. (Page 25)
1First turn on the power of the HDD (1394. a SBP2 supported) to be connected, and connect it using the IEEE1394 cable. Then turn the unit’s POWER switch to ON.
2Select 1394HOST for PC MODE on the setting menu OTHER FUNCTIONS screen, and press the button.
• For menu operations (Page 96)
3Press the MENU button twice to release the
menu mode.
MENU
4Press the mode button to light up the MCR lamp, and then hold the button down (for 2 or more seconds).
5Only when the hard disk drive is not formatted:
Select FORMAT (HDD) using the and
buttons, and press the
button.
Then select YES using the and
buttons, and press the
button.
Formatting now starts. (Formatting is completed in about 2 to 3 seconds.)
6When formatting is complete:
Select COPY TO HDD using the and
buttons, and press the
button.
•Data is copied onto the HDD on a card by card basis.
7Select the card slot using the and
buttons, and press the
button.
Then select YES using the and
buttons, and press the
button.
Copying now starts.
•You can carry out copying up to 15 times to one HDD.
The PC lamp now lights, and PC mode is | 8 When copying is complete: | ||
established. |
| ||
| Switch OFF the camera. | ||
CAMERA | |||
You cannot cancel the 1394 HOST mode even | |||
|
| ||
|
| if you press the operation mode button for an | |
MCR | VCR | extended period. | |
|
| ||
PC | DUB |
|
84