Adjustments and Settings for Recording

Multi Format

Video system and Recording format

For the unit to obtain image signals for each HD format, CCD is switching between interlaced scan and progressive scan (reading all pixels).

With combinations of the SYSTEM MODE and CAMERA MODE menu options on the <SYSTEM MODE> screen on the SYSTEM SETTING page, you can select an video system from among 13 types.

Selecting a recording signal and method

SYSTEM MODE menu option

Allows you to select a combination of system frequency (59.94 Hz, 50 Hz, 23.98 Hz and 24 Hz) and signaling system (1080i). When a change has been made to the SYSTEM MODE option, the viewfinder indicates “TURN POWER OFF”. Then, turn the POWER switch of the unit off and wait 5 seconds or longer before turning the unit on again.

REC FORMAT menu option

Used to select the recording format.

AVC-I 100

The AVC-Intra100 format is used to record video. The native recording format applies to the 30PN, 24PN and 25PN modes.

AVC-I 50

The AVC-Intra50 format is used to record video. The native recording is applied to the 30PN, 24PN and 25PN modes.

DVCPROHD

The DVCPRO HD format is used to record video.

CAMERA MODE menu option

Selecting a shooting mode. For information about the behavior for each setting, see [Recording formats and output connector signal formats] (page 50).

Notes

When the camera has been switched from 60i or 30P to 24P or 24PA, video may produce noise for a moment because the pull-down 5-frame cycle is adjusted. This is not an abnormal condition.

When “AVC-I 50” or “AVC-I 100” is selected, the 24PA mode cannot be selected.

VFR menu option

You can select whether to perform VFR recording.

ON Enables variable frame rate shooting at the frame rate set in FRAME RATE.

OFF The frame rate is determined according to the REC FORMAT setting.

24P VFR RANGE menu option

It is possible to increase the frame rate of VFR up to 30 frames when the SYSTEM MODE is set to “1080- 23.98PsF” or “1080-24PsF”.

24FRAME

1 to 24 frames can be set for VFR.

30FRAME

1 to 30 frames can be set for VFR. But the output image becomes unnatural because the HD SDI output signal sequence cannot be maintained correctly.

FRAME RATE menu option

When the VFR menu option is set to “ON”, it is possible to shoot using the frame rate set in this menu option. When the VFR menu option is set to “ON”, pressing the jog dial button displays the frame rate on the upper left of the viewfinder screen as a blinking number. It is then possible to change the frame rate setting without opening the FRAME RATE menu option by pressing the SYNCHRO SCAN adjustment buttons (+/-). Note, however, that this operation is not available when the FRATE function has been set to on using a user button.

Recording for Settings and Adjustments

Adjustments and Settings for Recording: Multi Format

49