Marker Check Screen Displays (MARKER SELECT button function)
The viewfinder can display a screen that allows you to view the marker settings of the unit.
Pressing the MARKER SELECT button on the unit switches the marker indication as follows.
MRK: A MRK: B MRK: OFF
If the menu option FRAME SIG is set to “14:9” as the information of Marker A and “4:3” as the information of Marker B, then the 14:9 and 4:3 view angles can easily be checked with the button, as required.
a
Markers
b c
d
b. Center marker
c.Safety zone
d.The view angle specified through the menu option FRAME SIG is displayed.
Recording for Settings and Adjustments
a. MARKER SELECT button
Checking Return Video Signal in the Viewfinder
The viewfinder displays the return video signal input to the GENLOCK IN connector while the RET button at the lens is held down.
Note, however, that the return video signal cannot be viewed unless the signal format set using SYSTEM MODE matches the input signal to the GENLOCK IN connector.
To enable this capability, select “CAM RET” for the menu option RET SW. This option can be found in the <SW MODE> screen on the CAM OPERATION page.
Note
1080/23.98P, 1080/24P and SD format signals cannot be viewed.
Adjustments and Settings for Recording: Viewfinder Screen Status Displays | 87 |