
P2 Store Manager screens (continued)
Setup pageFor checking and changing the unit's operating parameters.
You can specify whether HDD operation is suspended or remains active if the internal HDD temperature exceeds a prescribed level.
Options: [Suspend] and [Active]. Default: [Suspend].
The unit’s current setting is displayed in the “Current Setting” section.
If you change it, afterward click the [Apply] button .
Note:
Setting to [Active] may result in failure of the HDD.
Use this setting at your own risk.

You can specify the minimum ambient temperature at which HDD operation is permitted.
Options: [5 deg / 41 F] and
Default: [5 deg / 41 F].
The unit’s current setting is displayed in the
“Current Setting” section. If you change it,
afterward click the [Apply] button .
Note:
Setting to
Use this setting at your own risk.

Use [ON] and [OFF] to enable or disable impact detection when the unit is connected to a computer via the USB 2.0 cable.
[ON] (default):
Data transfer with the computer is suspended if the unit is hit.
[OFF]:
Data transfer is maintained even if the unit is hit.
The unit’s current setting is displayed in the “Current Setting” section.
If you change it, afterward click the [Apply] button .
Note:
The possibility of HDD failure is higher with the [OFF] setting than with the [ON] setting. Use this setting at your own risk.

You can specify the time until the unit switches OFF automatically if left unused (when no copying or formatting is in progress).
Options: [Never], [5 min], [10 min], [15 min], [20 min], [25 min], and [30 min].
Default: [10 min].
The unit’s current setting is displayed in the “Current Setting” section.
If you change it, afterward click the [Apply]
button . Note that auto power OFF is disabled when the unit is connected to a computer.

You can restore the default settings in sections
,
,
and
. However, note that the setup details are not applied automatically.
If you change them, click the [Apply] button .

You can save the setup details in sections ,
,
and
on the unit as follows. 1. Click the [Apply] button
A confirmation dialog is displayed.
2. Click [Yes]
The setup details are saved on the unit.
3.Restart the unit.
Note:
The new setup takes effect after the unit is restarted.