Panasonic AV-HS400AN manual  Camera control settings,  For controlling the lens zooming

5.System settings

Camera control settings

1 Press the [FUNC] button to light its indicator, and press the [SYSTEM] button to display the SYSTEM menu. 2 Turn [F1] to display the CamCTL1 sub menu.

<Menu display>

CamCTL1	Signal	CTL		Tally
3/16	IN1		1	Disable

IN1-8 1-5 Enable

None

3Turn [F2] to select the input signal using the Signal item.

4Turn [F3] to set the control signal (for the camera) that supports the input signal using the CTL item. Establish the associations between the switching of the cameras linked to the selection of the crosspoint buttons (PGM/A 1 to 10 and PST/B 1 to 10) and the tally control.

When camera control is enabled, the “c” mark appears on the multi view display in front of the names of the materials in the cameras targeted for control.

When “P/TDirt” has been selected as the protocol setting, only “1” appears.  See 5-6-3.

5Turn [F4] to enable or disable tally control using the Tally item.

This setting can be selected when “P/TDirt” has been selected as the protocol setting.  See 5-6-3. Enable: Tally control is enabled.

Red tally signal On/Off control is exercised from the RS-422 interface connector.

Disable: Tally control is disabled.

6Turn [F1] to display the CamCTL2 sub menu.

<Menu display>

CamCTL2	Signal	PosCont	Speed	Power↓
4/16	IN1	PanTilt	Fast	On
	IN1-8	Zm/Focs	Middle	Off
			Slow

7Turn [F2] to select the input signal using the Signal item.

8Turn [F3] to select the control to be exercised by operating the positioner using the PosCont item. PanTilt: Panning is controlled by left/right (X) operation; tilting is controlled by up/down (Y) operation. Zm/Focs: Lens focusing is controlled by left/right (X) operation; lens zooming is controlled by up/down (Y)

operation.

Each time the rotary encoder [Z] is pressed, the PanTilt or Zm/Focs setting is selected alternately.

 Control of lens focusing is possible when the

lens focus of the camera is set to manual

operation.

 Control using the positioner is possible when

For switching between

PanTilt and Zm/Focs

 For controlling the tilting

the CamCTL1 sub menu or CamCTL2 sub

menu is displayed.

 For controlling the lens zooming

Z

 If the crosspoint buttons (PGM/A 1 to 10 and

PST/B 1 to 10) are held down when “P/TCont”

or “P/TDirt” is selected as the Protcol item

setting, delegation to the CamCTL2 menu is

initiated.

POSITIONER

For controlling the panning

For controlling the lens focusing

95