Panasonic AW-RP50N Diag Speed, Scope Mode A, Setting the functions, Operations performed

Setting the functions

￿￿Setting the speed at which to move to the position set by the preset memory

The speed at which to move to the position where the remote camera has been set to be in the preset memory when the preset operation is conducted can be set.

From the [SETUP] menu, select [PRESET] and display [DIAG SPEED]. Then set the speed.

The higher the setting, the faster the operating speed.

1.DIAG SPEED ▼

1

￿￿Setting the operations to be performed when a preset operation is executed

The operations which the remote camera is to performed when the preset operation is conducted can be set.

From the [SETUP] menu, select [PRESET] and display [SCOPE].Then set the operations to be performed.

2.SCOPE

MODE A

The operations that the camera performs when a preset operation is executed differ depending on the mode selected.

Mode	Operations performed
MODE A	Pan, tilt, zoom, focus, iris, gain, white balance
MODE B	Pan, tilt, zoom, focus, iris
MODE C	Pan, tilt, zoom

Note

This function takes effect when the unit is connected to the AW-HE50. It does not work with any other models.

￿￿Adjusting the panning, tilting, zooming and focusing speed

The speed is adjusted uniformly for the panning, tilting, zooming and focusing together.

When the PTZ/FOCUS SPEED dial is turned clockwise, the speed is increased; conversely, when it is turned counterclockwise, it is reduced.

	1	2	3	4	5
IRIS	AUTO	CAMERA STATUS / SELECTION			PT ACTIVE

AUTO

LE

ZOOM

LOW HI

WIDE FOCUS/PUSH OAF PTZ/FOCUS SPEED PAN/TILT

From the [SETUP] menu, select [OPERATE] and display [SPEED TARGET]. If P/T is selected, the speed adjustment is confined to panning and tilting only.

In this case, the zooming and focusing speed is fixed to the speed which was set immediately before P/T was selected.

21