![](/images/new-backgrounds/1249049/249049119x1.webp)
Operating Instructions
| IKE Items | Settings | |
|
|
|
|
Phase 2 |
| Mode | Quick mode |
|
|
|
|
|
| PFS | Specifies either of Off, |
|
|
| H Group 2. |
|
|
|
|
|
| Cipher Algorithm | Select from |
|
|
| |
|
|
| (Multiple selections are available.) |
|
|
|
|
|
| ||
|
| Algorithm |
|
|
|
|
|
|
| Lifetime | Specifies by 28800 s (Byte setting is not |
|
|
| supported.) |
|
|
| |
*1 The camera does not support aggressive mode. |
•Set up the IPsec policy as the following.
Items | Settings |
|
|
Protocol | ANY |
|
|
Source Network | Network address and subnet mask on the LAN side of the |
| VPN router |
|
|
Source IP address | A global address on the WAN side of the VPN router |
|
|
Destination Network | A global address of the camera |
|
|
Destination IP address | A global address of the camera |
|
|
9.Access the camera (see page 13).
• If you can access the camera, the IPsec setup is complete.
Notes
•In IPsec communications, "IPsec" is displayed on the Top page or the Single Camera page.
•If you cannot communicate using IPsec, see 2.10 IPsec in the Troubleshooting section of the Installation/Troubleshooting.
•See the Panasonic Network Camera support website at http://panasonic.co.jp/pcc/products/en/netwkcam/ for the IPsec features.
60