Quick Guide

Charging the battery

Charging lamp [CHARGE] A

Lights up:

Charging

Goes off: Charging completed

1Connect the AC cable to the AC adaptor and the AC outlet.

2Insert the battery into the battery charger by aligning the arrows.

Inserting the battery

Open the LCD monitor and install the battery by inserting it in the direction shown in the figure.

AInsert the battery until it clicks and locks.

How to turn on the power

Turn on the power by turning the

mode dial to , or while pressing the lock release button A.

12

Rotate the mode dial while at the same time pressing in the lock release button if changing from OFF to another mode.

Status indicator B

Align with the mark C.

To turn off the power, set the mode dial to OFF.

Inserting/removing an SD card

Card access lamp [ACCESS]

When this unit is processing data, the access lamp A lights up.

1Set the mode dial to OFF.

2Open the SD card cover while sliding the SD CARD OPEN lever B.

3Insert/remove the SD card.

When inserting an SD card, face the terminal side C in the direction shown in the illustration and press it straight in as far as it will go.

When removing the SD card, press the center

of the SD card and then pull it straight out.

4Securely close the SD card cover.

≥ Securely close it until it clicks.

Language selection

1)Press the MENU button, then select [LANGUAGE] and press the cursor button.

2)Select [English] and press the cursor button.

VQT1N74

Page 12
Image 12
Panasonic HDC-HS9PC Quick Guide, Charging the battery, Inserting/removing an SD card Card access lamp Access