Problem
This unit cannot be operated though it is turned on.
This unit does not operate normally.
The remote control does not function.
The remaining time indication or the elapsed time indication is not shown.
Recording does not start although power is supplied to this unit and the SD card is correctly inserted.
The unit arbitrarily stops recording.
Recording starts but stops immediately.
Color balance of images is strange when recording in a place such as a gymnasium.
Check points
≥The unit cannot be operated if the LCD monitor is not opened.
≥Press the RESET button. (l 123) If normal conditions are not restored yet, remove the battery or AC adaptor, wait about 1 minute and then reconnect the battery or AC adaptor. Then about 1 minute later, turn on the power again. (Conducting the above operation while the HDD or SD card is being accessed may damage the data on the HDD or SD card.)
≥The
≥If you set [SETUP] > [DISPLAY] > [OFF], all indications other than warnings and date are not displayed.
≥Rotate the mode dial to select 
or 
.
≥No recording is possible while the SD card’s write protect switch is set to LOCK. (l 26)
≥If there is no more available memory of the SD card or HDD, free up some memory by deleting unnecessary scenes or use a new SD card. (l 27, 74)
≥If the SD card cover is open, this unit may not operate normally. Close the SD card cover.
≥Use an SD card that can be used for motion picture recording. (l 26)
≥If [AGS] is [ON], record in the normal horizontal position or set [AGS] to [OFF]. (l 37)
≥If the unit is exposed to strong vibrations or shocks while recording on HDD, recording may stop to protect the HDD.
≥The unit is disabled if the temperature is too high. Turn off the power of the unit and wait until the unit cools down.
≥In a place with multiple light sources, such as a gymnasium or a hall, the auto white balance function may not operate properly. In this case, adjust the white balance setting manually. (l 63)
