Important Information
Laser radiation
LThe printer of this unit utilises a laser. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
Fuser unit
LThe fuser unit gets hot. Do not touch it.
LDuring or immediately after printing, the area near the recording paper exit (1) also gets warm. This is normal.
–Do not place the drum unit near dust or dirt, or in a high humidity area.
–Do not expose the drum unit to direct sunlight.
WARNING:
LTo prevent the risk of fire or electrical shock, do not
expose this product to rain or any type of moisture.
LUnplug this unit from power outlets if it emits smoke, an abnormal smell or makes unusual noise. These
conditions can cause fire or electric shock. Confirm that smoke has stopped and contact an authorised service centre.
LMake sure that the unit is installed in a well ventilated room so as not to increase density of ozone in the air. Since ozone is heavier than air, it is recommended that air at floor level be ventilated.
For best performance
Toner cartridge and drum unit
1
Fuser unit
Toner cartridge
2
LFor optimal performance, genuine Panasonic toner cartridges and drum units are recommended. We cannot be responsible for problems that may be caused by a
–Damage to the unit
–Poor print quality
–Improper operation
LIn the printing process, heat is used to fuse toner onto the page. As a result, it is normal for the
machine to produce an odour during and shortly after printing. Be sure to use this unit in an area with proper ventilation.
LBe careful of the following when you handle the toner cartridge:
–Do not leave the toner cartridge out of the protection bag for a long time. It will decrease the toner life.
–If you ingest any toner, drink several glasses of water to dilute your stomach contents, and seek immediate medical treatment.
–If any toner comes into contact with your eyes, flush them thoroughly with water, and seek medical treatment.
–If any toner comes into contact with your skin, wash the area thoroughly with soap and water.
–If you inhale any toner, move to an area with fresh air and consult local medical personnel.
Drum unit
LRead the instructions on page 10 before you begin installation of the drum unit. After you have read them, open the drum unit protection bag. The drum unit contains a photosensitive drum. Exposing it to light may damage the drum. Once you have opened the protection bag:
–Do not expose the drum unit to light for more than 5 minutes.
–Do not touch or scratch the black drum surface.
LTo extend the life of the drum unit, the unit should never be turned OFF immediately after printing. Leave the power turned ON for a minimum of 30
minutes after printing.
LDo not cover slots or openings on the unit. Inspect the air circulation vents regularly and remove any
dust
LWhen replacing the toner cartridge or drum unit, do not allow dust, water, or liquids to come in contact with the drum. This may affect print quality.
Static electricity
LTo prevent static electricity damage to the interface connectors or other electrical components inside the unit, touch a grounded metal surface before touching the components.
Environment
LKeep the unit away from electrical noise generating
devices, such as fluorescent lamps and motors.
LThe unit should be kept free from dust, high temperature and vibration.
LThe unit should not be exposed to direct sunlight. L Do not place heavy objects on top of the unit.
L When you leave the unit unused for a long period of time, unplug this unit from the power outlet.
4