Pairing a headset to the base unit
Important:
RMake sure that the Bluetooth headset is not
connected to any other Bluetooth device.
1Your headset:
Set your headset to pairing mode.
RRefer to the headset operating
instructions.
2Handset:
MMENUN#621
3If your headset PIN is “0000”, go to
step 4.
If your headset PIN is other than
“0000”, press MCLEARN, then enter your
headset PIN.
RTypically, default PIN is “0000”. Refer
to the headset operating instructions.
4Press MOKN, then wait until a long beep
sounds.
5MOFFN
RWhen is displayed on the base
unit, the headset is available for use.

Connecting/disconnecting a headset

If you cannot connect the headset and base
unit using the headset, you can connect using
the unit.
To use your headset with another Bluetooth
device such as a cellular phone, you may
need to disconnect it from the base unit.
Important:
RMake sure that the headset is turned on.
Handset / Base unit
1To connect/disconnect:
MMENUN#622
RA long beep sounds.
2Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN

Unpairing a headset

You can cancel a pairing of the headset that is
stored to the base unit.
Handset
1MMENUN#612
2MbN: “Yes” a MSELECTN
RWhen the headset is unpaired, the
disappears from the base unit
display.
3MOFFN
Operating a Bluetooth wirelessheadset using a landline
Important:
RRefer to your headset operating instructions
for headset operations.

Answering landline calls with your

headset

To answer a landline call, turn on your
headset referring to your headset operating
instructions.
When you finish talking, turn off your headset
referring to your headset operating
instructions.
Note:
RIf you cannot hang up the call using your
headset, press MZN on the base unit 2
times.

Switching between the base unit and

your headset

You can switch between the base unit and
your headset:
– during a landline call with the base unit
speakerphone.
– during an intercom call between the base
unit and handset.
– while listening to messages recorded on
the base unit answering system.
nTo switch to your headset:
Press MN on the base unit.
nTo switch to the base unit:
Press MZN on the base unit.
54 For assistance, please visit http://www.panasonic.com/help
Using Bluetooth Devices
TG78xx(en)_1210_ver101.pdf 54 2012/12/10 21:19:30