Installation Instructions for Stacking

English

IMPORTANT

1.Disconnect the power cord from the wall socket before attempting installation.

2.For stacking installation, you must use the PANASONIC Joint Plate which is enclosed with this unit.

3.Combination of the unit for stacking is limited within only the following PANASONIC models:

NE-1057, NE-1457, NE-1247, NE-1747, NE-1047,

NE-1447, NE-1257, NE-1757, NE-1442, NE-1856, NE-1456, NE-1846, NE-1446, NE-2146-2, NE-2156-2

4.The maximum stacking height is the total heights of two units.

PREPARATION

Be sure the oven cavity is empty.

INSTALLATION

1.Stack the units and remove five screws (a) as shown in Fig.1.

2.Loosen the screw (b).

3.Projection on Joint Plate must face away from the oven. Place Joint Plate on the screw (b).

4.Attach and tighten five screws (a) and the screw (b). See Fig.2.

5.Ensure the top oven is at a safe and workable height.

(b)

Joint Plate

 

Projection

Joint Plate

Projection

(a)

Fig. 1

Fig. 2

 

Self Diagnostics Failure Code Explanation

This oven monitors its operation and displays a Failure Code in Digital Display Window when a problem occurs. What to do when a Failure Code appears: Unplug the oven and wait more than ten seconds before reconnecting. If normal operation does not resume, follow the next chart.

CODE

PROBLEM

WHAT TO DO

 

 

 

F01

Too high temperature of

The oven shuts off automatically. Disconnect the power cord from the wall socket.

 

exhausted air

The oven beeps continuously and resets for operation when cool. Move the oven

 

 

to the cooler location. If the problem persists, call service agent.

 

 

 

F33-34

Defective thermistor circuit

The oven shuts off automatically. If the problem persists, call service agent.

 

 

 

F05

Defective memory IC

If the problem persists, call service agent. The oven will operate even if Failure

 

 

Code appears, just not as designed. If the problem occurs during memory

 

 

heating, press Stop/Reset pad. Then other memory program and manual heating

 

 

will be possible.

 

 

If the problem persists, call service agent. The oven will operate even if Failure

F81-82

Defective relay circuit

 

 

Code appears, just not as designed. Press Stop/Reset pad and try again.

 

 

 

F86-87

Defective relay circuit

The oven shuts off automatically. If the problem persists, call service agent.

 

 

 

F44

Defective control panel

The oven shuts off automatically. If the problem persists, call service agent.

 

 

 

Note: Above codes shown in Digital Display Window do not indicate all possible failures on the unit.

- 13 -