Before Using
Accessories
Check that all of the accessories shown below have been included with your projector.
Remote Control | Power cord | |||
Batteries for Remote | For Continental | Eye bolt | Wire | |
[N2QAYB000076 × 1] | For U.K. | |||
Control (AA) | [K2CM3YY00007 × 1] | [TPAHE86 × 4] | [TTRA0143 × 4] | |
| [K2CT3YY00014 × 1] | |||
Caution when moving the projector
The projection lens is susceptible to vibrations and impacts. Be sure to always remove the lens during transport.
Cautions regarding setup
Be sure to observe the following precautions when installing the product.
Be sure to install the projection lens cover after installing the projection lens.
If this is not done, dust will collect inside the projector and problems with the projector will result.
Avoid installing the product in a place exposed to vibrations or impacts.
If the projector is installed in a place where vibrations are transmitted from a source of driving power and others or mounted in a car, vibrations or impacts may be transmitted to the product to damage the internal parts, causing failure. Install the product in a place free from vibrations and impacts.
Do not install the projector near
The product may be exposed to interference if it is installed in the vicinity of
Do not place the projector on a vinyl sheet or carpet.
If a vinyl sheet sucked up and blocks the air filter intake port, the internal temperature of the projector may increase, which triggers the protection circuit, turning off the power.
Be sure to ask a specialized technician when to install the product to a ceiling.
If the product is to be installed hanging from the ceiling, purchase an optional hanging attachment (for high ceiling: Model No.
Do not place the projector over 2 700 m above sea level. When using it over 1 400 m above sea level, set the “ALTITUDE MODE”, described on
page 76, to “ON”.
Otherwise the life of the product may be shortened.
When installing and using the projector at an angle that exceeds 30°from the horizontal in the vertical direction, set “DIRECTION”, described on page 76, to “VERTICAL”.
