Adjusting the picture (continued)
3.Press ◄► to switch “COLOR TEMPERATURE”.
•The setting will change as follows each time ◄► is pressed.
DEFAULT 
USER1 
USER2
| HIGH |
| MIDDLE |
| LOW |
|
|
|
|
|
•When any setting other than “OFF” has been selected for colour matching, the COLOR TEMPERATURE setting is fixed at “USER1”.
•“DEFAULT” cannot be selected when the picture mode has been set to “USER”.
To further adjust toward the desired white balance
4.Select “USER1” or “USER2” in Step 3.
5.Press ENTER.
•The “WHITE BALANCE” screen will be displayed.
WHITE BALANCE
WHITE BALANCE HIGH
WHITE BALANCE LOW
6.Press ▲▼ to select “WHITE BALANCE HIGH” or “WHITE BALANCE LOW”.
7.Press ENTER.
Note
•All colours will not be displayed properly unless adequate adjustment is made. If the adjustment does not look suitable, you can press DEFAULT to return the setting for the selected item only to the factory default setting.
•The colour temperature cannot be adjusted for the internal test pattern (p. 85). Be sure to project the input signal when adjusting the colour temperature.
Gamma setting
This switches the gamma mode.
1. Press ▲▼ to select “GAMMA”.
| COLOR TEMPERATURE | DEFAULT |
|
| |
| GAMMA | DEFAULT |
|
| |
| SHARPNESS | 0 |
|
|
|
|
|
|
|
|
|
2.Press ◄► or ENTER.
•The “GAMMA” individual adjustment screen will be displayed.
GAMMA | DEFAULT |
|
CHANGE
3.Press ◄► to switch “GAMMA”.
•The setting will change as follows each time ◄► is pressed.
DEFAULT 
USER1* 
USER2*
| 2.6 |
| 2.5 |
| 2.2 |
|
|
|
|
|
•The “WHITE BALANCE HIGH (LOW)” screen will be displayed.
WHITE BALANCE HIGH
RED | 255 |
|
|
GREEN | 255 |
|
|
|
|
|
|
8.Press ▲▼ to select “RED”, “GREEN” or “BLUE”.
9.Press ◄► to adjust the level.
Item | Operation | Adjustment | Adjustment | |
range | ||||
|
|
| ||
| Press ► | Deepens red. | Maximum | |
RED | button. |
| value | |
Press ◄ | Weakens red. | HIGH : 255 | ||
| ||||
| LOW : 127 | |||
| button. |
| ||
| Press ► | Deepens green. | Minimum | |
GREEN | button. |
| value | |
Press ◄ |
| |||
| Weakens green. | HIGH : 0 | ||
| button. |
| LOW : | |
| Press ► | Deepens blue. | ||
| Default | |||
BLUE | button. |
| ||
Press ◄ | Weakens blue. | HIGH : 255 | ||
| ||||
| LOW : 0 | |||
| button. |
|
*“USER1” and “USER2” appear when the setting was set with a control command from the serial terminal.
Note
•“DEFAULT” cannot be selected when the picture mode has been set to “USER”.
