Easy Cassette Eject/Insertion
•If the Palmcorder is connected to a power source, the cassette can be inserted and ejected without turning the Palmcorder on.
1TAPE EJECT 3PUSH 
CLOSE
Cassette
Compartment
Cover
Note
•When inserting the cassette, make sure it is facing the right direction and then push it in completely.
•If Hand Strap is tight it may prevent Cassette Holder from fully opening for Cassette insert or eject. Loosen Hand Strap if necessary.
Before Using
Before you begin
•Connect the Palmcorder to a power source. (pp. 15, 16)
1 Slide TAPE EJECT to open the Cassette Compartment Cover.
2 Insert a cassette record tab up, window side facing out.
3 Press PUSH CLOSE to close the Cassette Compartment Cover.
•To remove the cassette...
Slide TAPE EJECT to open the Cassette Compartment Cover and pull the cassette tape straight out.
Before Use
Attaching the Shoulder Strap
1 Undo the two strap ends from their
buckles.
2 Thread the strap end through the Strap Attachment Rings.
• Tilt Viewfinder upward.
3 Reinsert the strap ends through
their buckles. |
| 2 | |
• Make sure the straps | 3 | ||
1 | |||
are not twisted. |
Adjust the Length
1 Loosen the strap from the Buckle and create a loop.
2 Pull the strap firmly through the Buckle to shorten or lengthen the
strap.
1
Hand Strap
Adjust the length of the Hand Strap to the size of your hand as illustrated.
12
3
Hand Strap
Lens Cap
Attaching the Lens Cap Strap: Thread the Lens Cap Strap through the Strap Attachment Ring as shown. 
Attaching the Lens Cap Strap to the Hand Strap:
Remove the Hand Strap from the front clasp and thread the Strap through the loop in the Lens Cap Strap. Reattach the Hand Strap. 
7
