Card PhotoShot
You can record still images to a Memory Card.
Warning
•When using an
3PHOTOSHOT
2JOG KEY
2MENU
1POWER
Image Resolution and Capacity (Supplied 8MB Memory Card)
REC | Image | Capacity | |
Mode | Resolution | ||
| |||
FINE | 1280 x 960 | Approx. 30 images | |
NORMAL | 640 x 480 | Approx. 70 images |
•The number of images given for each mode applies when all images are taken in same mode.
•You can change recording modes at any time before capturing an image.
•The number of images that can be captured may differ depending on the subject. After capturing an image, the number may not decrease, or it may decrease by two. This is normal.
Note
•1280 x 960 PhotoShot image is interpolated from 640 x 480 image.
•Some artifacting, softened edges or picture noise may occur in Fine (1280 x 960) Mode.
•PhotoShot capture time for Fine Mode (1280 x 960) is approximately 10 seconds, and for Normal Mode (640 x 480) is approx. 5 seconds.
Card Features
Before you begin
•Connect the Palmcorder to a power source. (pp. 15, 16)
•Set POWER to OFF before inserting a Memory Card. (p. 14)
1 Set POWER to M-CARD.
•The POWER lamp lights red.
•Be sure POWER is fully turned to
•“PLAY: PUSH PLAY KEY” is displayed for 10 seconds. (p. 51)
2 Press MENU to display CARD SETUP menu, then press JOG KEY to select NORMAL or FINE .
•Press MENU to exit this menu.
3 Press PHOTOSHOT to record an |
|
image. | Card |
| |
• When SHTR EFFECT is set to ON | Features |
• The PhotoShot image is recorded to |
|
the Memory Card.
(Menu OSD: p. 109), still pictures are recorded with a visual shutter effect and click sound. If set to OFF, the still image will be displayed only.
Warning
•While “PROCESSING” is displayed, DO
NOT turn off the Palmcorder or unplug the AC Adaptor (supplied) because this will cause irreversible damage to the memory.
•When recording DV Tape playback output to the Memory Card, only NORMAL mode is available. (p. 50)
49
