Panasonic PV-GS9 Power Supply, Using the Remote Control PV-GS15 Only, Using the AC Adaptor

Before Use

•When the button-type battery is exhausted, replace it with a new CR2025 battery. (A battery is normally expected to last about 1 year. However, it depends on operation frequency.)

•Make sure to match the poles correctly when inserting the button-type battery.

WARNING

●Replace Battery with Panasonic or Lixing type CR2025 only. Use of another battery may present a risk of fire or explosion.

●Battery may explode if mistreated.

●As with any small object, this type of Battery can be swallowed by young children. Do not allow children to handle this Battery.

CAUTION

●Dispose of used battery promptly.

●Do not recharge, disassemble or dispose of in fire.

Using the Remote Control

(PV-GS15 Only)

1Direct the Remote Control at the Remote Control Sensor 31 of the Camcorder and press an appropriate button.

15°15°31

15° 15°

•Distance from the Camcorder: Within approximately 15 feet (5 meters)

•Angle: Within approximately 15° in the vertical and horizontal directions from the central axis

•The above operating ranges are for indoor use Outdoors or under strong light, the Camcorder may not operate properly even within the above ranges.

Selecting Remote Control Modes

When 2 Camcorders are used simultaneously, they can be operated individually by selecting different Remote Control Modes.

•If the Remote Control Mode of the Camcorder and that of the Remote Control do not match, [CHECK REMOTE MODE (REMOTE)] Indication is displayed.

Setup on the Camcorder:

Set [REMOTE] on the [INITIAL] Sub-Menu to the desired Remote Control Mode. (p. 21)

Setup on the Remote Control:

2 1

[VCR1]:

Press the [ ] Button and [ ] Button simultaneously. 1

[VCR2]:

Press the [ ] Button and [ ] Button simultaneously. 2

•When the battery in the Remote Control is replaced, the mode is automatically reset to [VCR1] Mode.

Power Supply

Using the AC Adaptor

1Connect the DC Cable to the Camcorder.

2Connect the DC Cable to the AC Adaptor.

3Connect the AC Cable to the AC Adaptor and the AC Jack.

•Before connecting or disconnecting the power supply, set the [OFF/ON] Switch 44 on the

Camcorder to [OFF] and make sure that [POWER] Lamp is not lit. (p. 18)

Using the Battery

Before use, fully charge the Battery.

•We recommend using a Panasonic Battery.

•We cannot guarantee the quality of this Camcorder when batteries from other companies are used.

1Attach the Battery to the AC Adaptor and charge it.

15