Panasonic UB-5338C, UB-5838C operating instructions Optional Stand

Assembling the unit

7	After unscrew the 4 screws from the lower
	center frame cover, remove it.

[Optional Stand]

10 Attach the optional stand to the unit.

•Each stands has four holes (A, B, C, D).

1)Attach the stand to the unit with the locking caster up.

2)When attaching the unit to the stand at normal height (1,830 mm [6' 2/32" ]), tighten the two screws (included in the stand) with 1 washers using the hexagonal wrench through holes A and C.

[Normal height]

8	Fasten the wall-mounting clasps of the unit
	securely to the wall with the 4 appropriate wall-

mounting hardware.

Screw

1Washer

C

B

A

Wall-mounting hardware

Note

•The 4 wall-mounting hardware are not included with the electronic board. Please purchase M6-size screws appropriate for your wall.

9 Attach the lower frame cover removed in step 7.

•Advance to “Electronic Board Operations Check” on page 45.

Note

•Use the washer included with the electronic board. Do not use the washer included with the stand.

•Do not tighten the screw too much. This may deform the stand.

•By tightening the two screws with washers through holes A and B, the unit will be positioned 100 mm (3 15/16" ) higher than normal height (1,930 mm [6' 4" ]).

[higher than normal height]

C

B

A

Installation

43