Panasonic UB-5838C Electronic Board Operations Check Operation Check Procedure, Step, Condition

Electronic Board Operations Check

■Operation Check Procedure

After assembling the unit and setting the time, perform the procedures presented in the following table to make sure it functions properly.

	Step	Points to Check
		Condition	Solutions
1	Turn the power switch on.	The standby message is displayed	(Normal operation)
		after the initial message is
		displayed.
		Display does not appear.	Check the power cord.
			(See step 2 on page 45.)
		An error code appears on the	Contact the store or dealer from
		display.	which the unit was purchased.
2	Press the Advance Key.	Screen is fed.	(Normal operation)
		The screen film surface is not fed	Contact the store or dealer from
		smoothly.	which the unit was purchased.
		There are strange noises.
3	Connect a USB flash memory	The USB flash memory device or	(Normal operation)
	device or SD memory card.	SD memory card installed is shown
		on the display.
		(If not)	Contact the store or dealer from
			which the unit was purchased.
4	Use the accessory marker	The screen film moves smoothly	(Normal operation)
	to draw a large	and the scanned image appears on
		the display.
	across the entire
	scannable area of the
	screen film surface.
		(If not)	Contact the store or dealer from
	• For information on the
			which the unit was purchased.
	scannable area, refer to
	“Screen Film” on page 12.
	Press the Start/Stop Key.
5	Zoom in on several areas of the	A black or white horizontal line	Check the strong lighting.
	scanned image.	appears on the scanned image, or
	(See page 18 and 19.)	the image scanned is dark or blank.
		The entire scannable area is not	Contact the store or dealer from
		scanned.	which the unit was purchased.
6	Turn off the power switch, then	The standby message is displayed	(Normal operation)
	turn back on after 3 minutes.	after the initial message is
		displayed.
		The time is not correct.	Check the battery.
			(See step 3 on page 45.)

46