29
LSQT0969
Setup
Inserting/removing an SD card (VDR-D200 only)
Inserting/removing an SD card (VDR-D200 only)Before inserting/removing an SD card, be sure to turn off the power.
If the SD card is inserted or removed with the power turned on, this unit may malfunction or the data
recorded on the SD card may be lost.
1 Open the card slot cover.
2 Insert/remove the SD card into/from the card slot.
≥When inserting an SD card, face the label side A upwards and press
it straight in with one stroke as far as it goes.
≥When removing the SD card, press the center of the SD card and then
pull it straight out.
3 Securely close the card slot cover.
∫Concerning the SD card
≥Electrical noise, static electricity or failure of this unit or the SD card may damage or erase the
data stored on the SD card. We recommend saving important data on a computer.
∫Card access lamp
≥When this unit accesses the SD card (reading, recording, playback, erasing, etc.), the access
lamp lights up.
≥If the following operations are performed when the access lamp is lit, then the SD card or the
recorded data may be damaged or this unit may malfunction.
– Inserting or removing the SD card
– Operating the OFF/ON switch or the mode dial
– Removing the battery or disconnecting the AC adaptor
A
D200(P_PC)eng.book 29 ページ ２００６年１月１８日 水曜日 午後５時４６分