26
LSQT0969
Setup
Power supply
1 Connect the AC cable to the AC adaptor and
the AC outlet.
2 Connect the DC cable to the AC adaptor.
3 Connect the DC cable to this unit.
≥Do not use the AC cable for other equipment since the AC
cable is exclusively designed for this unit. Do not use the AC
cable from other equipment for this unit.
≥While the DC cable is connected to the AC adap tor,
the battery will not charge.
≥When recording, remove the lens cap before turning the unit on.
If the unit is turned on with the lens cap fitted, the automatic white balance adjustment may not
function properly.
While pressing the button A, set the
OFF/ON switch to ON.
The status indicator B lights red.
≥The date and time display flashes. Set this. (l38)
While pressing the button A, set the OFF/ON switch to
OFF.
The status indicator B goes off.
Connecting to the AC outletTurning the unit on/off
How to turn on the power
A
B
How to turn off the power
A
B
When the power is turned on for the first time after changing the disc or battery, the unit carries
out a recognition procedure to check that there are no problems with the disc.
This takes approximately 25 seconds with DVD-RAM.
If you want to start using the unit as soon as you turn on the power, do the following.
1) Turn on the power.
2) After “READINGDISC...” disappears from the screen, turn off the power.
You can start recording approximately 8 seconds after you turn on the power again.
≥Depending on the condition of the disc, it may take longer than this.
≥If the date and time are not set, this function does not work.
D200(P_PC)eng.book 26 ページ ２００６年１月１８日　水曜日　午後５時４６分