Panasonic VDR-D100 operating instructions 140, VCD/DVD2

Troubleshooting

	Problem	Check points
		≥ What version of Mac OS X are you using? If it is V10.3.x or
	DVD-RAM or DVD-RW	earlier, the icon is not displayed even if the disc is
	(VR format) icon is not	recognized by the computer. Use Disk Utility or Apple
	displayed on the desktop.	System Profiler to verify if the disc is recognized by the
		computer.
	When Pixe VRF Browser	≥ Is there a disc in this unit when Pixe VRF Browser EX is
	EX is started, a message
	is displayed about	started?
		# Insert the disc after starting Pixe VRF Browser EX.
	ejecting the disc.
		≥ Is there a file with a compatible format in the folder? Check
		the help for ImageMixer VCD/DVD2.
	Cannot register the file	≥ In [Options] in the [Select folder], confirm the small box for
	with ImageMixer VCD/	[Add sub-folder(s)] is checked.
	DVD2.	≥ The same folder cannot be selected simultaneously in
		DVD-Video mode and Video CD mode. In [Selected
		folder(s)] for the mode not being used, delete the folder.
	Cannot select this unit as	≥ Cannot write to this unit with ImageMixer VCD/DVD2.
	the write destination	# To create a DVD-Video disc, a separate DVD-RW/DVD-R/
	drive with ImageMixer
		+RW/+R drive is required.
	VCD/DVD2.
		≥ If there is a disc in the drive before ImageMixer VCD/DVD2
	The disc for writing is not	is started, the drive will not be recognized properly.
		# 1) Click the upper-right save icon and save the settings.
	recognized by	2) Exit from ImageMixer VCD/DVD2 and remove the disc.
	ImageMixer VCD/DVD2.	3) Start ImageMixer VCD/DVD2 again, click the [Load
		Project] button to read the file with the saved settings.
		4) Proceed with [Write to Disc] again.
	The message [There is no	≥ There is not enough work space to write to the disc.
	work disk space.] is	# Click the [Preferences] button on the upper-right of
	displayed and the data	ImageMixer VCD/DVD2 and select a work space with a large
	cannot write to disc.	amount of free space.
	The DISC EJECT lever	≥ The DISC EJECT lever does not work after the unit is
	does not work when the
		connected to the computer. Use the software’s eject button
	unit is connected to the
		to eject the disc.
	computer.
Others
	When the USB cable is	≥ When the drive icon is displayed on the desktop, drag the
	disconnected, an error	icon into the Trash and then disconnect the USB cable.
	message will appear on	≥ When the drive icon is not displayed on the desktop, exit
	the computer.	the application and then disconnect the USB cable.

140

LSQT0969