ND400_Basic.book 15 ページ 2008年4月8日 火曜日 午後3時59分
Major Operating Controls and Their Functions
Rear View
(1)(2) | (3) | (4) | (1) |
(5) | (6) | (7) | (8) | (9) | (10) |
(1) Handle for Maintenance | (10) Power switch [POWER] |
Loosen the 5 screws indicated by the triangles and grip these | Turns the power on. Press it again to turn the power off and |
handles to pull off the panel when replacing the fan or doing | end operations. |
other maintenance work. |
|
(2) Alarm/Control connector [ALARM/ CONTROL],
Use to connect alarm devices (buzzers or indicators), external devices, control switches controlled by the recorder.
(3) Alarm connector [ALARM], D-sub 25 pin
Use to connect
(4) Cable clamp fixing holes
Install the cable clamp (provided with the extension unit) to secure the connection cables.
For details refer to the manual for the extension unit (WJ- HDE400).
(5) External storage connector [EXT STORAGE]
Use to connect the
Using the Brace
Secure the power cord with the brace.
1 Lock the power cord in place by lifting and latching the brace.
Brace
(6) Client PC port [PC]
Use to connect a PC,
(7) Camera port [CAMERA]
Use to connect a camera,
(8) Signal GND terminal [SIGNAL GND]
Use as a ground when the recorder's Signal GND terminal is connected to another device's Signal GND terminal. Static or other noise related problems may occur if a ground is not connected.
(9) Power cord Inlet [AC IN]
Connect the provided power cord here. The power plug is a two prong plug with a ground terminal.
15