ND400_Basic.book 39 ページ 2008年4月8日 火曜日 午後3時59分
Power Supply
Turning On the Power
Turn on the recorder.
1 Insert the power plug to an outlet.
120 V AC, 60 Hz for NTSC model
220 V - 240 V AC, 50 Hz for PAL model
•Make sure the power source matches the power requirement of the model in use.
2 Turn on the [POWER] switch on the rear of the recorder.
•The operate indicator lights and recorder/HDD check (system check) begins.
•During system check,
•The Time display format screen appears when the system check is complete (page 40).
Important:
•When using extension units
Turning Off the Power
Turn off the recorder.
Important:
•When the recorder is not in use for an extended period of time, unplug the power plug.
•Be sure to turn the power on and operate once a week to check recording and playback functionality.
During Recording
1 Set [Basic] - [Basic] - [Recording] on the settings menu to [Off] and stop all recording (refer to the Setup Instructions (PDF file)).
2 Turn off the [POWER] switch on the rear of the recorder after checking that the HDD indicators are off.
The operate indicator goes off.
Note:
•Do not forget to start recording when you turn on the power.
During Playback
1 Click the [STOP] button on the [HDD] tab to stop playback (refer to the Operating Instructions (PDF file)).
2 Turn off the [POWER] switch on the rear of the recorder after checking that the HDD indicators are off.
The operate indicator goes off.
39