ND400_Basic.book 16 ページ 2008年4月8日 火曜日 午後3時59分
Outline of Functions
HDD
Mega Pixel Camera Compatibility and Capacity
The recorder can record
HDD Space Management
The HDDs in the recorder are virtually divided in the 4 image areas shown below (refer to the Setup Instructions (PDF file)).
You can set only one area for each HDD.
Display on 21 in PC monitor
Normal Recording Area | (1) |
| |
Event Recording Area | (2) |
| |
| (3) |
Area |
|
SXGA (1280 x 960) pixels
Conventional VGA (640 x 480) pixels
Copy Area
(4)
You can install up to 9 HDDs to record
You can check the remaining capacity for each area on the Setup menu.
Replace HDDs
Replacement is Easy
You can install and remove HDDs by opening the front panel.
If more than two HDDs are installed, replacement can be done without stopping recording. Instructions are shown on the LCD to reduce misoperations, and make maintaining and replacing HDDs easy.
Use the special HDD canister provided to install the HDD.
The HDD unit is an HDD that is in the special canister. The HDD units can be easily installed or removed from the HDD bay slots inside the front cover.
*Contact your dealer for information on purchasing and replacing HDDs.
(1) Normal Recording Area
Area for recording except events.
Manual recording/schedule recording/SD memory data
(2) Event Recording Area
Area for recording when events occur.
(3) Pre-event Recording Area
Area for
(4) Copy area
Area where copied data is saved.
Note:
•The HDD provided in the recorder at the factory is initialized as normal recording area. Unformatted HDDs inserted into the recorder are automatically initialized as normal recording area.
•Recording/playback is not possible if only the
•If a normal recording area is not created, manual and schedule recordings are recorded to the event recording area. Also, if an event recording area is not created, event and emergency recordings are recorded to the normal recording area.
16