ND400_Basic.book 22 ページ ２００８年４月８日 火曜日 午後３時５９分
Getting Started
Setup Procedure
The procedure to start operations is shown below.
1 | Rack Mounting |
2 | Connections |
3 | Power On |
4 | Installing HDDs |
5 | Recorder Network Settings |
6 | PC Network Settings |
7 | Initialize HDDs |
8 | Camera Network Settings |
9 | Setup |
10 | Start Operations |
When necessary
Replace HDDs
Mount the recorder into the rack (page 23).
Go to step 2 if you are not using a rack.
Connect the recorder to the various devices (page 25).
Turn on the recorder (page 39).
When using extension units, turn on all extension units before turning on the recorder.
Install the HDDs in the recorder (page 46).
Unformatted HDDs inserted into the recorder are automatically initialized. Also, set the HDD operation mode as necessary (page 51).
Use the buttons on the recorder's front panel to do the network settings (refer to the Setup Instructions (PDF file)).
Change the PC's network settings to match the recorder's settings (refer to the Setup Instructions (PDF file)).
To change HDD space management, display disk configuration and initialize the HDD from the settings menu on the recorder as needed (refer to the Setup Instructions (PDF file)).
Open the PC settings menu from the PC and do the network settings (refer to the Setup Instructions (PDF file)).
Set up the functions that you need (refer to the Setup Instructions (PDF file)).
You can change or format HDDs while the recorder is [On].
22
