Configure the network settings [NETWORK]
Configure the network settings. When connecting the camera to a network, it is necessary to configure the network settings such as IP address, etc.
The settings can be configured on the "NETWORK SETUP" page.
Refer to the operating instructions (book) for descriptions of how to display the "NETWORK SETUP" page.
Note:
Before configuring the settings, refer to the network administrator or the Internet service provider for the following information.
•IP address
•Net mask
•Default gateway (when using the gateway server/router)
•HTTP port Number
NETWORK SETUP page
**NETWORK SETUP**
DHCP OFF
IP ADDR 192.168. 0. 10 NETMASK 255.255.255.128 GATEWAY 192.168. 0. 1
HTTP PORT NO. 80
RET TOP END
[DHCP]
The default network settings are as follows.
DHCP:OFF
IP ADDRESS: 192.168.0.10
NETMASK: 255.255.255.0
GATEWAY: 192.168.0.1
HTTP PORT NO.: 80
Select "ON" or "OFF" to determine whether or not to use the DHCP function.
[IP ADDR]
When not using the DHCP function, enter the IP address of the camera.
[NETMASK]
When not using the DHCP function, enter the net mask of the camera.
[GATEWAY]
When not using the DHCP function, enter the default gateway of the camera.
[HTTP PORT NO.]
Assign the port numbers independently.
Note:
Refer to page 39 for further information about the network settings.
55
