Paradyne 8968, 8965, and 8985, 8955 manual Field, Description, Both - Both L2 and L3 low power modes

3. Configuration Using the Web Interface

Field	Description
Power Management	Specify whether power management is supported on this
	port:
	￿Enabled - Power management is enabled
	Disabled - Power management is disabled
	Power management refers to the following modes, defined
	in￿the ADSL2 specification:
	L2 low power: Power consumption is reduced at the
	local unit when there is no traffic. Entry to and exit from
	L2 low power mode happens so quickly that it is
	￿undetectable by the user.
	L3 low power: The port enters sleep mode during
	extended periods of inactivity, saving power at both the
	local and remote units.
Power Management State	Select the line states that the port may autonomously
Enabling	switch to on this line:
	Idle – L3 low-power mode
	Low Power – L2 low power mode
	￿Both – Both L2 and L3 low power modes
	None – Power management is disabled
L0 Time	Specify the minimum number of seconds allowed between
	an exit from the low power (L2) state and the next entry into
	the low power state.
L2 Time	Specify the minimum number of seconds allowed between:
	An entry into the low power (L2) state and the first
	￿power trim in the low power state
	Two consecutive power trims in the low power state
Port Status	Select Enabled, Disabled, or Reset from the drop-down list
	to determine the status of the port.

3. Click on Apply.

3-4 June 2004 8900-A2-GB20-30