L o a d i n g L a b e l s f o r t h e O p t i o n a l P e e l M o d e :

Peel mode is an option that must be purchased separately. In peel mode, the printer separates the backing paper from the label. The next label is not printed until the completed one is removed from the printer. Make sure the printer is configured for on-demand mode and the correct supply type.

The minimum feed length is 1.5 inches for peel mode. We recommend using 0.5-inch gap supplies in peel mode when backfeed is disabled. Hold the leading edge of peeled labels when printing on stock longer than six inches. You must use non-perforated supplies for peel mode. Follow the steps for loading supplies from the previous section. Then, follow these steps after you close the printhead.

1.Remove the labels from the first 10 inches of the backing paper.

2.Press down on the exit cover tabs to open the exit cover on the front of the printer.

Exit Cover

2-6Loading Supplies

Page 20
Image 20
Paxar 9800 Series manual 6Loading Supplies