C o n n e c t i n g t h e P o w e r C a b l e

The power supply automatically switches between 115V or 230V. No operator settings are required.

1.Plug the power cable into the socket. Plug the other end of the cable into a grounded electrical outlet.

2.Turn on the printer. Press ( I ) to turn on and ( O ) to turn off the printer.

E s t a b l i s h i n g C o m m u n i c a t i o n s

Before the printer can accept print jobs from the host, you must:

Connect the communication cable to the printer and to the host.

Set the communication values on the printer to match those at the host. (Only required if you are using the serial port.)

Make sure the printer is off before connecting the cable to the communication port.

Parallel Port

Power Cable

goes here Serial Port

Ask your System Administrator which method you will use to communicate with the host:

Serial Communication 9 to 25 pin cable (Part #118364)

25 to 25 pin cable (Part #118366)

Parallel Communication IEEE-1284 or Centronics® mode cable (Part #118363)

Getting Started 1-3

Page 9
Image 9
Paxar 9800 Series manual N n e c t i n g t h e P o w e r C a b l e, T a b l i s h i n g C o m m u n i c a t i o n s