C1300M-C 11/08 | Pelco C1300M-C (11/08) manual

10	C1300M-C (11/08)

Image 10

Pelco C1300M-C (11/08) manual C1300M-C 11/08

Contents

ExSite Series Explosionproof Positioning System Page Contents Specifications Regulatory Notices Radio and Television Interference Models Configure DoneWelcome Getting Started How to Operate Your System KBD200A/KBD300A Direct Mode only Accessing Main Menu PresetKBD4000/KBD4002 Genex Multiplexer Quick Start Guide System Setup C1300M-C 11/08 Language OFF default Use for normal installations refer to Figure Unit Inversion System Information Display Setup Label Positions Unit Settings Camera IR CUT Filter 23X DAY/NIGHT Camera Dark Shutter Speed Advanced Camera SettingsAGC Limit Auto White Balance Auto IrisAuto Sharpness Gain Wide Dynamic Range 23X DAY/NIGHT Camera Backlight Compensation BLCVideo Level Normal Proportional PAN There are two proportional pan modes On defaultMotion Amount of zoom Park Time Scan Speed Preset Freeze FrameThere are three preset freeze frame settings Image is never frozen Scan Limit StopsManual Limit stop is reached Azimuth Zero Power UP Action Power UPNone Line Sync Phase settings range from 0-359 degreesSystem synchronizes to an internal clock Presets Enable Motion Detection 23X DAY/NIGHT Camera Edit Detection Areas 23X DAY/NIGHT Camera Triggers a command to AUX Activate AUX Command 23X DAY/NIGHT CameraAUX Time 23X DAY/NIGHT Camera Patterns Zones Window Blanking To set a window blanking area Clear Window Available OFF default No blankingReverse Blank ALL ABOVE/BLANK ALL below Resume AlarmsReset Delay Sequence MEDIUM/LOW Normally open Wiper Control Wiper ModeWiper Wiper Dwell SET Washer Sequence Received from the controller When the dwell time is finishedAUX Latching Clear Password Position Calibration Cycle Camera Power Reset, Cycle Power, RebootReset Camera Reboot System Software/Language File Upload Upload Icon Ntsc SpecificationsNTSC, PAL PAL Product Warranty and Return Information