Pelco C1300M-C (11/08) manual Patterns

PELCO EXSITE IPSXM

LANGUAGE	ENGLISH
UNIT INVERSION	OFF
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
UNIT SETTINGS
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>
BACK
EXIT
PATTERNS
PATTERN NUMBER	1
<PROGRAM PATTERN>
<CLEAR PATTERN>
BACK
EXIT
REFERENCE INFORMATION
PATTERN USAGE	0%
REMAINING	100%

PATTERNS

A pattern is a memorized, repeating, series of pan, tilt, zoom and preset functions that can be recalled with a command from a controller or automatically by a programmed function (alarm, park or power-up).

The ExSite IPSXM can handle up to four user-defined patterns. Pattern length is based upon memory usage rather than a fixed amount of time. The complexity of a pattern will determine the amount of storage available to program other patterns.

To program a pattern:

1.Use the joystick to position the cursor beside PATTERN NUMBER. Press Iris Open. The cursor moves to the right.

2.Move the joystick up or down to view selections. Press Iris Open to enter selection.

3.Use the joystick to position the cursor beside PROGRAM PATTERN.

4.Press Iris Open. The Patterns programming window appears on the monitor.

5.Follow the directions displayed on the monitor.

After a pattern is programmed, the remaining storage percentage is displayed on the screen. This is the amount of memory available to program the remaining patterns.

To clear a pattern:

1.Use the joystick to position the cursor beside CLEAR PATTERN.

2.Press Iris Open.

3.Follow the directions displayed on the monitor.

NOTES:

•When programming one or more presets within a pattern use the normal controller commands to Call a Preset.

•Not all controllers can start all four patterns. However, any of the four patterns can be automatically started with park, power-up, and alarm functions.

Quick Programming Guide

(See Page 9)

C1300M-C (11/08) 31