Manuals / Pelco / Personal Care / Sleep Apnea Machine

Pelco C1300M-C (11/08) manual

Models: C1300M-C (11/08)

1 48

Download 48 pages 19.52 Kb

Page 48

www.pelco.com

Pelco, Inc. Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA

USA & Canada Tel (800) 289-9100 Fax (800) 289-9150

International Tel +1 (559) 292-1981 Fax +1 (559) 348-1120

Image 48

Pelco C1300M-C (11/08) manual

Contents

ExSite Series Explosionproof Positioning System Page Contents Specifications Regulatory Notices Radio and Television InterferenceConfigure Done WelcomeModels Getting StartedHow to Operate Your System Accessing Main Menu Preset KBD200A/KBD300A Direct Mode onlyKBD4000/KBD4002 Genex Multiplexer Quick Start Guide System Setup C1300M-C 11/08 Language OFF default Use for normal installations refer to Figure Unit InversionSystem Information Display Setup Label Positions Unit Settings CameraIR CUT Filter 23X DAY/NIGHT Camera DarkAdvanced Camera Settings Shutter SpeedAGC Limit Auto Iris Auto SharpnessAuto White Balance GainBacklight Compensation BLC Video LevelWide Dynamic Range 23X DAY/NIGHT Camera NormalThere are two proportional pan modes On default MotionProportional PAN Amount of zoomPark Time Preset Freeze Frame There are three preset freeze frame settingsScan Speed Image is never frozenLimit Stops ManualScan Limit stop is reachedAzimuth Zero Power UP Power UP ActionNone Phase settings range from 0-359 degrees Line SyncSystem synchronizes to an internal clock Presets Enable Motion Detection 23X DAY/NIGHT Camera Edit Detection Areas 23X DAY/NIGHT CameraActivate AUX Command 23X DAY/NIGHT Camera Triggers a command to AUXAUX Time 23X DAY/NIGHT Camera Patterns Zones Window Blanking To set a window blanking areaAvailable OFF default No blanking ReverseClear Window Blank ALL ABOVE/BLANK ALL belowAlarms Reset DelayResume SequenceMEDIUM/LOW Normally open Wiper Mode WiperWiper Control Wiper DwellSET Washer Sequence When the dwell time is finished AUXReceived from the controller LatchingClear Password Position Calibration Reset, Cycle Power, Reboot Reset CameraCycle Camera Power Reboot SystemSoftware/Language File Upload Upload IconSpecifications NTSC, PALNtsc PALProduct Warranty and Return Information