ALARMS
PELCO EXSITE IPSXM
LANGUAGE | ENGLISH | |||
UNIT INVERSION | OFF | |||
<SYSTEM INFORMATION> |
| |||
<DISPLAY SETUP> |
| |||
<UNIT SETTINGS> |
| |||
<POSITION CALIBRATION> |
| |||
RESET CAMERA |
| |||
CYCLE CAMERA POWER |
| |||
REBOOT SYSTEM |
| |||
EXIT |
| |||
|
|
|
| |
|
|
|
|
|
UNIT SETTINGS |
| |||
|
| |||
<CAMERA> |
| |||
<MOTION> |
| |||
<POWER UP> |
| |||
<LINE SYNC> |
| |||
<PRESETS> |
| |||
<PATTERNS> |
| |||
<ZONES> |
| |||
<WINDOW BLANKING> |
| |||
<ALARMS> |
| |||
<WIPER> |
| |||
<AUX> |
| |||
<CLEAR> |
| |||
<PASSWORD> |
| |||
BACK |
| |||
EXIT |
| |||
|
| |||
|
|
|
|
|
ALARMS |
| |||
|
| |||
|
|
|
|
|
RESUME | OFF | |||
SEQUENCE (SECS) | 5 | |||
RESET DELAY (SECS) |
| |||
<ALARM SETTINGS> |
| |||
BACK |
| |||
EXIT |
| |||
The ExSite IPSXM system has seven alarm inputs, which can be programmed as high, medium or low priority. When an alarm is received, an input signal to the unit triggers the
There are three global alarm settings:
RESUME | This mode lets the system resume its previous activity (scan, pattern, or |
| previous position) after all alarms are cleared. |
SEQUENCE | This is the time the system will perform an alarm activity when more than one |
| alarm of the same priority occurs at the same time. |
RESET DELAY | This is the amount of time the system considers the alarm to be active after it |
| has physically cleared. |
Use the following steps to program alarm settings.
1.Use the joystick to position the cursor beside ALARM SETTINGS. Press Iris Open.
2.Select the alarm number:
a.Use the joystick to position the cursor beside ALARM NUMBER.
b.Press Iris Open. The cursor moves to the right.
c.Move the joystick up or down to view selections. Press Iris Open to enter selection.
Quick Programming Guide
(See Page 9)
35 |
