Display Setup

PELCO EXSITE IPSXM

LANGUAGE

ENGLISH

UNIT INVERSION

OFF

<SYSTEM INFORMATION>

 

<DISPLAY SETUP>

 

<UNIT SETTINGS>

 

<POSITION CALIBRATION>

 

RESET CAMERA

 

CYCLE CAMERA POWER

 

REBOOT SYSTEM

 

EXIT

 

 

 

 

 

 

 

 

 

 

DISPLAY SETUP

 

 

 

 

 

 

 

 

PRESET LABEL

2 (SECS)

ZONE LABEL

2 (SECS)

ZOOM

2 (SECS)

AZIMUTH/ELEVATION

2 (SECS)

DIRECTION

OFF

ALARM MESSAGE

2 (SECS)

<LABEL POSITIONS>

 

RESTORE FACTORY DEFAULTS

 

BACK

 

EXIT

 

Display setup allows you to program how labels are displayed on the monitor. The following labels are available:

PRESET LABEL

Identifies preset.

ZONE LABEL

Identifies zone.

ZOOM

Identifies the amount of magnification.

AZIMUTH*/

Amount of pan from 0° and the amount of tilt from 0° horizontal.

ELEVATION**

 

DIRECTION

Displays compass direction.

ALARM MESSAGE

Displays activated alarm.

A preset label is displayed when a preset is called. A zone label is displayed when the system moves into a zone. The zoom ratio label is displayed when zoom is activated. Azimuth/elevation and direction labels are displayed when pan/tilt is activated. An alarm message appears on the monitor when an alarm occurs.

The following settings are available for each label:

OFF

Label is not displayed when activated.

CONSTANT

The label is continually displayed when activated.

2 SECONDS

The label is displayed for 2 seconds after activation.

5 SECONDS

The label is displayed for 5 seconds after activation.

10 SECONDS

The label is displayed for 10 seconds after activation.

*Azimuth is the pan angle from 0 to 359 degrees.

**Elevation is the tilt position from +90 (horizon) to -90 degrees.

14

C1300M-C (11/08)

Page 14
Image 14
Pelco C1300M-C (11/08) manual Display Setup