PELCO EXSITE IPSXM

LANGUAGE

ENGLISH

UNIT INVERSION

OFF

<SYSTEM INFORMATION>

 

<DISPLAY SETUP>

 

<UNIT SETTINGS>

 

<POSITION CALIBRATION>

 

RESET CAMERA

 

CYCLE CAMERA POWER

 

REBOOT SYSTEM

 

EXIT

 

 

 

 

 

 

 

 

 

 

UNIT SETTINGS

 

<CAMERA>

 

<MOTION>

 

<POWER UP>

 

<LINE SYNC>

 

<PRESETS>

 

<PATTERNS>

 

<ZONES>

 

<WINDOW BLANKING>

 

<ALARMS>

 

<WIPER>

 

<AUX>

 

<CLEAR>

 

<PASSWORD>

 

BACK

 

EXIT

 

 

 

 

 

 

 

 

AUX

 

 

 

AUX 1 MODE

TOGGLE

DWELL TIME (SECS)

1

AUX 2 MODE

TOGGLE

DWELL TIME (SECS)

1

BACK

 

EXIT

 

AUX

An auxiliary output is a programmable signal from the system that can trigger another device to operate. An auxiliary output is programmable to trigger from an alarm or from a controller.

An AUX 1 command from the controller will activate the relay in the system and operate the device that is connected to the relay. The output of AUX 1 can be connected to the alarm input of a system switch to activate automatic monitor switching and recording.

An AUX 2 command from the controller will place a ground at the output of AUX 2 to operate the device that is connected to it.

The following are the available AUX MODE settings:

TOGGLE (default)

Changes the state of the auxiliary output every time an AUX command is

 

received from the controller.

LATCHING

Must receive an AUX ON/AUX OFF command from the controller to turn the

 

auxiliary output on/off.

MOMENTARY

An AUX ON command from the controller turns the auxiliary output on for the

 

programmed DWELL TIME. The auxiliary output will automatically turn off

 

when the dwell time is finished.

40

C1300M-C (11/08)

Page 40
Image 40
Pelco C1300M-C (11/08) manual Received from the controller, Latching, Auxiliary output on/off