Unit Inversion

PELCO EXSITE IPSXM

LANGUAGE

ENGLISH

UNIT INVERSION

OFF

Unit inversion reconfigures the system so that it operates normally when it is installed in an inverted postion. The following are the available settings for unit inversion.

<SYSTEM INFORMATION> <DISPLAY SETUP> <UNIT SETTINGS> <POSITION CALIBRATION>

RESET CAMERA

CYCLE CAMERA POWER REBOOT SYSTEM

EXIT

OFF (default)

Use for normal installations (refer to Figure 1).

ON

Reconfigures the camera oriention and controller functions for inverted

 

operation when the unit is installed in an inverted position (refer to Figure 1).

 

 

 

 

 

 

 

 

 

 

 

 

STANDARD

INVERTED

INSTALLATION

INSTALLATION

Figure 1. Installation Methods

To reconfigure the unit for inverted operation and control:

1.Use the joystick to position the cursor beside UNIT INVERSION.

2.Press Iris Open. The cursor moves to the right.

3.Move the joystick up or down to view selections. Press Iris Open to enter selection. The system will start a configuration sequence. When configuration is completed, the camera will be oriented in the correct position for the installation.

12

C1300M-C (11/08)

Page 12
Image 12
Pelco C1300M-C (11/08) manual Unit Inversion, OFF default Use for normal installations refer to Figure