120
4 Use the four-way controller (n) to select K (Manual).
White Balance
Manual
OK 
Adjust
OK OK
5
Press the four-way controller (p).
The message screen appears.
Manual
White Balance
Point camera at subject
Press the shutter
release button
5 FunctionReference
6
7
8
Fully display a white or gray sheet of paper in the viewfinder under the light to adjust white balance.
Press the shutter release button fully.
Slide the focus mode lever to \ when the shutter cannot be released. [OK] appears on the LCD monitor when setting is completed.
[NG] appears when setting is not completed successfully.
Press the 4 button.
•No image is recorded when the shutter release button is pressed to adjust the white balance.
•Press the {button when adjustment is unsuccessful to set again.
•You can use [Man. WB Measurement] in the [ACustom Setting] menu (p.107) to set the area to measure for white balance when setting manually. Even if [Entire screen] is selected, white balance of the entire screen is measured normally but the exposure metering is measured according to the [AE Metering] setting in the [A Rec. Mode] menu (p.136). White Balance is only adjusted in the spot metering area (p.137) if [Spot metering area] is selected.
•If picture is extremely overexposed or underexposed, white balance may not be adjusted. In this case, adjust appropriate exposure and adjust the white balance.
