![](/images/new-backgrounds/1139081/13908129x1.webp)
4 Align the film leader with the film leader end mark and make sure that the film leader is posi- tioned under the film retainer as shown in the illustration.
Memo
•If the end of the film leader is extremely bent, straighten it or cut off the bent portion.
•If you have pulled out too much film, push it back into the cartridge to reduce the slack.
5 Close the back cover.
6 Turn the main switch to [ON].
The film will advance to frame 1 automati- cally, and the LCD panel will display the exposure counter 1 and film status infor- mation.
Memo Incorrect film loading
If the film is not loaded properly, the LCD panel will display . Open the back cover and load the film again.
Film retainer
Film leader end mark
Film status information
Exposure counter
20