Philips WARNING, TROUBLESHOOTING, PROBLEM, English, SOLUTION, No sound, speakers, Bad sound, Pro Logic, POSSIBLE CAUSE, No sound on the, Poor bass sound

TROUBLESHOOTING

WARNING		If a fault occurs, first check the points listed, before taking
Under no circumstances should you try to repair the		the set for repair.
		If you are unable to solve a problem by following these hints,
set yourself as this will invalidate the guarantee. Do
not open the set as there is a risk of electric shock.		consult your dealer or service center.
PROBLEM	POSSIBLE CAUSE		SOLUTION
Set does not work	The overheating safety circuit		Switch the set off and let it cool down. After
and is in standby mode	has been activated.		having let the set cool down switch it on again
			and select a source by rotating SOURCE SELECT
			or pressing a source key on the remote control.
No sound	VOLUME is not correctly adjusted.		Adjust the VOLUME.
	Headphones are connected.		Disconnect headphones.
	The wrong source is selected.		Turn SOURCE SELECT to select the correct
			source.
No sound on the	One speaker is wrongly connected.		Connect the speaker properly.
left or right side	A speaker cable is damaged.		Replace the cable.
	Volume balance in the receiver menu is		Adjust VOL FRONT-L and VOL FRONT-R
	wrongly adjusted.		in the receiver menu.
Poor sound or no sound at	SURROUND mode is not switched on.		Press SURROUND ON/OFF to switch on the
the center or surround			surround sound.
speakers	Surround and/or center speakers are not		Connect the speakers properly.
	(properly) connected.
	Surround and/or center speakers are switched		Set speaker present to YES.
	off in the SPEAKR SETUP menu.
	A speaker cable is damaged.		Replace the cable.
Poor bass sound	Speakers are not in phase.		Connect the coloured (or marked) wires to the
			coloured terminals and the black (or unmarked)
			wires to the black terminals.
Bad sound	Badly matching setting for the given type of		Correct the sound settings on the receiver.
	music or sound.
Surround sound level is	The level of the surround sound is not		Adjust the level of the surround sound on
too low or too high	properly adjusted.		the receiver.
Center sound level is too	The sound level of the center channel is not		Adjust the level of the center channel
low or too high	properly adjusted.		on the receiver.
Only center speaker is	A mono signal is reproduced.		Choose a different sound source or switch off
heard in Dolby Surround			surround sound.
Pro Logic
Bad radio reception,	Receiver or antenna is positioned near a		Change the position of the interfering unit
automatic programming	radiation source such as a TV, CD player,		or try to switch it off.
does not work properly	CD recorder, DVD player, etc.
No digital recording	The sampling frequency is not accepted by		Make sure the digital recorder can handle
possible via digital output	the digital recorder.		sampling frequencies between 32 kHz and 48 kHz
			or make the recording via analogue output.
Whole recording appears	The DVD player does not provide track		Record each track individually or use the
as one track when	information.		“manual track increment” feature on the recorder.
recording from DVD disc

English

25