How can I record from a satellite receiver?
It is also posssible to programme recordings from an external satellite receiver.
!Connect the satellite receiver with the socket u. Make sure that the satellite receiver is switched on and tuned to the desired satellite station.
"Programme a TIMER block using one of the already described methods. Select the programme position "E2" for the external programme source (satellite receiver).
Note:
*If you use "Programming with ShowView" for the Timer recording from the "external" satellite receiver, the video recorder selects automatically the programme position "E2".
In this case, you can ignore the message "Please enter programme number".
RS 232
2 EXTERNAL / DEC.- AV 2
| AUDIO |
|
L | L | 1 EXTERNAL / |
O | I |
|
U | N | |
T |
RR
A few general notes on programming
•The programmed recording will always be effected with the recording speed (SP or LP) selected in the OSD page "PERSONAL PREFERENCES".
•If you have forgotten to insert a cassette before programming, the recorder's display indicates "NO CASS".
•If you insert a cassette with erase protection for the recording, the indication "PROTECTED" briefly appears in the video recorder's display after you have finished programming. The cassette is then ejected.
•TIMER recording is only possible if the video recorder is switched off. If the video recorder is switched on before a programmed recording, the message "TIMER REC" flashes in the display.
•If the recording times of the TIMER blocks overlap each other, the message "COLLISION" appears in the video recorder's display.
In this case , you must correct or clear the data of one TIMER block. How this is done is explained in the paragraphs "How can I check, clear or correct a TIMER block?"
•If you have programmed all TIMER blocks, the message "FULL" appears in the video recorder's display. Refer to the paragraphs "How can I check, clear or correct a TIMER block?
•If the end of the cassette is reached during a TIMER recording, the recorder ejects the cassette. The video recorder's display indicates "TIMER REC".
Insert a "new" cassette into the video recorder then press the dbutton on the remote con- trol to resume the TIMER recording.
•If TIMER recordings are programmed, the video recorder cannot be switched in the "save energy mode"
24
