The system and the other setup 11
103
En
English Français
Deutsch
Nederlands
Italiano Español
1 Select ‘
Speaker Distance
’ from the
Manual SP Setup
menu.
2 Adjust the distance of each speaker using
/
.
You can adjust the distance of each speaker in
1/2 inch increments.
3 When you’re finished, press
RETURN
.
You will return to the Manual SP Setup menu.
Tip
• For best surround sound, make sure the
surround back speakers are the same
distance from the listening position.
X-Curve
Most soundtracks mixed for cinema sound too
bright when played back in large rooms. The X-
Curve setting acts as a kind of re-equalization
for home theater listening, and restores proper
tonal balance of movie soundtracks.
1 Select ‘
X-Curve
’ from the
Manual SP
Setup
menu.
2 Choose the X-Curve setting you want.
Use / to adjust the setting. The X-Curve is
expressed as a downwards slope in decibels
per octave, starting at 2 kHz. The sound
becomes less bright as the slope increases (to
a maximum of –3.0dB/oct). Use the following
guidelines to set the X-Curve according to your
room size:
•If you select OFF, the frequency curve will
be flat and the X-Curve has no effect.
3 When you’re finished, press
RETURN
.
Network Setup menu
Setting up the network to listen to Internet
radio on this receiver.
1 Press on the remote control,
then press
HOME MENU
.
A Graphical User Interface (GUI) screen
appears on your TV. Use /// and
ENTER to navigate through the screens and
select menu items. Press RETURN to confirm
and exit the current menu.
2 Select ‘
System Setup
’ from the
HOME
MENU
.
3 Select ‘
Network Setup
’ from the
System
Setup
.
4 Select the setting you want to adjust.
If you are doing this for the first time, you may
want to adjust these settings in order:
•IP Address, Proxy – Sets up the IP
address/Proxy of this receiver (see below).
•Information – Checks the MAC address of
this receiver (page 104).
IP address/Proxy setting
In case the router connected to the LAN
terminal on this receiver is a broadband router
(with the built-in DHCP server function), simply
turn on the DHCP server function, and you will
not need to set up the network manually. You
must set up the network as described below
only when you have connected this receiver to
a broadband router without the DHCP server
function. Before you set up the network,
consult with your ISP or the network manager
for the required settings. It is advisory that you
also refer to the operation manual supplied
with your network component.1
Room size (ft
2
)
≤
400
≤
550
≤
650
≤
800
≤
2200
≤
12000
X-Curve
(dB/oct)
–0.5 –1.0 –1.5 –2.0 –2.5 –3.0
Note
1 In case you make changes to the network configuration without the DHCP server function, make the corresponding
changes to the network settings of this receiver.
RECEIVER
VSX-1020_UC.book 103 ページ ２０１０年���月７日 木曜日 午後６時０分